Using The Usb Floppy Disk Drive; Connecting 3 1/2" Floppy Disk Drive - Toshiba Tecra M2 User Manual

The peg is square, so be careful to align the cap's square hole with the
peg.

Using the USB floppy disk drive

A 3 1/2" floppy disk drive connects to the computer's USB port. It
accommodates 1.44-megabyte or 720-kilobyte floppy disks. Refer to
Chapter 2,

Connecting 3 1/2" floppy disk drive

To connect the drive, plug the floppy disk drive connector into a USB port.
Refer to Figure 4-3.
Make sure the connector is right side up and properly aligned with the
socket. Do not try to force the connection; doing so can damage the
connecting pins.
If you connect the floppy disk drive after turning on the computer, it will
take about 10 seconds for the computer to recognize the drive. Do not
disconnect and reconnect before 10 seconds has elapsed.
User's Manual
1. To remove the AccuPoint cap, firmly pinch the cap and pull it
straight up.
Figure 4-2 Removing the AccuPoint cap
2. Position a new cap on the peg and press it into place.
The Grand Tour, for more information.
Figure 4-3 Connecting the USB floppy disk drive
Operating Basics
4-3