Remote Control; How To Insert Batteries Into Remote Control - Kenmore 580.73069300 Owner's Manual

REMOTE CONTROL
Note: The Remote Control willnot operateproperly if
stronglightshineson the sensorwindowof the Air
Conditioneror if there are obstaclesbetweenthe Remote
Controland the AirConditioner.
Everytimeyou push button,youwill hear bsep sound
from the Air Conditioner.
1 6 3
4 2 5
5 m <_,_ m3
5. TIMER
- SHUT-OFF TIME
• You willusuallyuse shut-offtime while yousleep.
• With unitrunning,use Timer to set numberof hours
untilshut-off.
• For yoursleeping comfort,onceTime is set, the
Temperaturesettingwill raise2"F after30 min, and
2°F after another 30 min.
• Everytimeyou pushTimer button,it advancesthe
Timer settingas follows:1 Hour_ 2 Hours --,etc. -,
12 Hoursmaximum.
- START TIME
• With unitnot running, use timerto set number of
hoursbeforeunit starts.
• Everytime youpushTimer button,it advancesthe
Timer settingas follows: 1 Hour _ 2 Hours _ etc.
12 Hours maximum.
HOW TO INSERT BATTERIES
INTO REMOTE CONTROL
1. Remove the coverfrom the back of the remote controller.
2. Insert two batteries.
• Be sure that the (+) and (-) directions are correct.
• Be sure that both batteries are new.
3. Re-attach the cover.
m
FIG. 16
REMOTE CONTROL OPERATIONS
1. POWER
• To turnthe air conditionerON, push this button.
To turnthe air conditionerOFF, pushthe button
again.
• This button takespriorityover any otherbutton.
• When youfirst turn it on, the unitis in coolmode, High
fan speed, Temperaturesettingat 72'F.
2. TEMPERATURE SETTING
• Use this buttonto automatically control the
temperatureofthe room.
The temperaturecan be set withina rangeof 60°F to
86°F by increments of I°F.
3. MODE
- Every time you push thisbutton, it willshift among
COOL, ENERGY SAVER and FAN.
- ENERGY SAVER
• The fan stops whenthe compressor stops cooling.
Approximately every 3 minutes the fan will turn on and
the unit will check the room air to determine if cooling
is needed.
4. FAN SPEED
• Every time you push thisbutton, it advances the setting
as follows: {High(F3) > Low(F1) _ Med(F2) _ High(F3)}
-12-
__IG. 17
• Do not use rechargeablebatteries. Such battehes
differ from standard dry cells in shape,dimensions, and
performance.
• Remove the batteries from the remote controller if the air
conditioner is not going to be used for an extended
length of time,
• In order to prevent discharge, remove the batteries from
the remote control if the air conditioner is not going to be
used for an extended period of time. Keep the remote
control away from extremely hot or humid places. To
maintain optimal operation of the remote control, the
remote sensor should not be exposed to direct sunlight.
• The remote control can be mounted on a wall using the
mountable holder.
FIG. 18