If Something Goes Wrong; Technical Specifications - Kuppersbusch EEBG 6400.8 MX Technical Specifications

If Something Goes Wrong

The oven stops working
Check the power connection.
Check the fuses and circuit breaker
of your electrical system.
Make sure the clock is in
manual or programmed mode.
Check the position of the function and
temperature selector.
The inside light does not go on
Change the bulb.
Follow the Instruction Manual carefully
for correct assembly.
The heating pilot light does not turn on
Select a temperature.
Select a function.
It must only go on while the oven
is heating up to reach the
programmed temperature.
38
Oven smoking during use
Normal during first use.
Clean the oven regularly.
Remove the grease or oil falling
into the tray.
Do not use higher temperature
settings than those indicated
on the cooking chart.
The expected cooking results
are not achieved
Review the cooking chart to gain an idea
about how your oven works.
Caution
If these problems persist despite our tips,
contact Technical Service.

Technical Specifications

If the appliance does not work, inform
Technical Service of the kind of problem you
are experiencing and give the:
1 Serial Number (S-No)
2 Model of Appliance (Mod.)
You will find this information engraved on the
identification plate. This plate is on the bottom
of the oven and can be seen when opening the
door.
The appliance you have bought complies
with the EU Directives on Safety of Electrical
Material (73/23/EEC) and Electromagnetic
Compatibility (89/336/EEC).
Installation
This information is exclusively for the installer
who is responsible for assembly and electrical
connection. If you install the oven yourself, the
manufacturer will not accept responsibility for
possible damage.
Prior to Installation.
Observations
• To unpack the oven, pull on the tab located
at the bottom of the box.
• The opening in the kitchen unit must be that
indicated on the diagram. The minimum size
of the unit base must be 580 mm. (See
Figure 1 on Page 67)
• The rear of the unit, corresponding to the
shaded area in Figure 2 (see Page 67), must
have nothing projecting out (unit reinforce-
ment, pipes, sockets, etc.).
• The adhesive used in the plastic lining the
kitchen units must be able to withstand
temperatures over 85 o C.
Electrical Connection.
Legal Requirements
The installer must ensure that:
• The mains power voltage and cycles
correspond to what is marked on the
identification plate.
• The domestic wiring system can withstand
the maximum power marked on the
identification plate.
• The connection diagram is shown in the
following figure.
• The electrical connection has an adequate
ear th connection in accordance with
regulations in force.
• Connection must be made by means of an
omnipolar switch that is suitable for the
current drawn and with a minimum
aperture between contacts of 3 mm for
disconnection in case of emergency,
cleaning or bulb changing. Under no
circumstances must the earth wire pass
through this switch.
After making connection, check that all
electrical parts of the oven are working
correctly.
39