Display - Kenmore 580.75281 Owner's Manual

CONTROL PANEL
_FAN SPEED
• Every time you push this button, it advances the setting as follows: {High -_ Low -* Med-_ High}
REMOTE CONTROL SIGNAL
RECEIVER
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range
of 60°F to 86°F by increments of 1°F.
• The setting appears in the display.
POWER
• To turn the air conditionerON, push the button.
To turn the air conditioner OFF, push
the buttonagain.
-TIMER
• This buttontakes priority over any other button.
- SHUT-OFF TIME • When you first turn it on, the air conditioneris on
• You will usually use shut-off time while you sleep, the Highcool mode and the Temp. at 7Z'F.
• If unit is running, usetimer to set number of hours until shut-off. • Auto restart
• For your sleepingcomfort,oncetimer isset, the thmperature In the event as a powerfalture, the unit wil! run
at the previoussetting once power returns.
settingwilt raige2°F after 30minand onceagainafter another 30min.
• Push timer buttonto advance setting from 1 Hour -, 2Hour..... -12 Hoursmaximum.
- START TIME
• If unit is off, Timer sets number of hours before unit starts.
• Push timer buttonto advance setting from 1 Hour -_ 2Hour..... -.12 Hoursmaximum.
MODE
- Push this button to shift mode of operation from cool-, energy saver-_ fan.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on so that the unit can check the room air to determine if
cooling is needed.
1
In failure of electric power, the unit runs as previous setting operation. J
HORIZONTAL AIR DIRECTION CONTROL VERTICAL AIR DIRECTION CONTROL
The vertical air direction is adjusted by moving the
The horizontal air direction is adjusted by moving horizontal louvers up and down with your fingertips.
the vertical louvers right and left with your (FIG. 25)
fingertips. (FIG. 24)
FIG. 24 FIG. 25
-11-