Dust Bag Changing - Kenmore 116.33922 Owner's Manual

Check motor safety filter frequently and
change when dirty.
!
WARNING
ElectricalShock Hazard
Unplug power cord from electdcal out-
let. Do not operate the cleaner without
the motor safety filter. Be sure the fil-
ter is dry and properlyinstalled to pre-
vent motor failure and/or electrical
shock.
Remove the dust bag as outlined in the
DUST BAG CHANGING section.
MOTOR SAFETY FILTER
ELECTROSTATIC
1. The filter must be
replaced when dirty.
It should be replaced
regularly depending
on use conditions.
The filter CANNOT
be washed as it will \
lose its dust trapping
ability.
Motor
Note: See PARTS AND FEATURES for
motor safety filter number.
Motor
2. If the filter, locat-
ed in the bottom of
the bag cavity, is
dirty, remove it by
pulling forward out
from under the
ribs.
3. Replace the
filter, smooth side
up, by sliding it
back into place
under the ribs in
the bag cavity.
Satery ,_"_
Filter
Replace the bag as outlined in the DUST
BAG CHANGING section.
EXHAUST FILTER
HEn
WARNING
Do not operate without exhaust
filter.
I
The exhaust filter cartridge must be
replaced when dirty. It should be replaced
regularly depending on use conditions. The
filter CANNOT be washed as it will lose its
dust trapping ability.
Note: See PARTS AND FEATURES for the
exhaust filter number.
Slide the exhaust
filter cover
release down.
Pull out on
exhaust filter
cover to remove
from bag cover.
Bag I_
Cover-...ZI
Exhaust _1_
Filt__
F
Bag
Cove
Exhaust
Remove the
exhaust filter car-
tridge from the bag
cover.
Replace the exhaust
filter cartridge, care-
fully positioning it so
that it fits into the bag
cover. The grey edge
of the filter should be
facing away from the
operator. Push only
on filter cartridge
frame, not on filter itself.
Exhaust Filter t
Cover Release -_
Exhaust I
Bag
Exhaust
i eplace the
exhaust filter
cover and
secure the
latch by push-
ing it upward.
16