Advanced Menu; Reset Configuration Data - TYAN S5393 Manual

3.3 Advanced Menu

This section facilitates configuring advanced BIOS options for your system.
Main Advanced
Hardware Monitoring
BIOS Event Logging
Advanced Chipset Control
Advanced Processor Options
Diskette Controller
ATA Controller
LSI SAS Interface
Integrated Network Interface
Onboard VGA
Integrated USB
I/O Device Configuration
PCI Configuration

Reset Configuration Data

Route Port 80h cycles to
Console Redirection
F1 Help
↑↓
Esc Exit
← →
Reset Configuration Data
If you install a new piece of hardware or modify your computer's hardware configuration,
the BIOS will automatically detect the changes and reconfigure the ESCD (Extended
System Configuration Data). Therefore, there is usually no need to manually force the
BIOS to reconfigure the ESCD.
However, sometimes, the BIOS may not be able to detect the hardware changes. A
serious resource conflict may occur and the operating system may not even boot as a
result. This is where the Reset Configuration Data BIOS feature comes in.
This BIOS feature allows you to manually force the BIOS to clear the previously saved
ESCD data and reconfigure the settings. All you need to do is enable this BIOS feature
and then reboot your computer. The new ESCD should resolve the conflict and allow the
operating system to load normally.
Please note that the BIOS will automatically reset it to the default setting of No after
reconfiguring the new ESCD. So, there is no need for you to manually disable this feature
after rebooting.
No / Yes
Route Port 80h cycles to
LPC---Route Port 80h I/O cycles to the LPC bus.
PCI----Route Port 80h I/O cycles to the LPC bus.
PhoenixBIOS Setup Utility
Security
[No]
[PCI]
Select Item -/+
Select Menu Enter
http://www.tyan.com
TPM State Power
Change Values
Select
Sub-Menu
38
Boot
Item Specific Help
Hardware monitoring
configuration
F9 Setup Defaults
F10 Save and Exit
Exit