Reviewing Waypoints - Garmin GPS 95AVD Owner's Manual

· Select the desired waypoint category (airport, VOR or NDB only) by
pressing CLR (repeatedly).
· Press the right arrow key twice to place the cursor on the facility name.
· Enter the starting letter, or letters, of the facility name. You may limit
the scan to the desired level by designating the number of starting
letters (as described previously when scanning by identifier).
· Press WPT to begin scanning.
· Press the right arrow key to sequence through the available waypoints.
If you pass the desired waypoint, you may press the left arrow key to
scan backwards through the list.
· Once the desired waypoint is selected, press ENT to accept the
waypoint and complete the scan. The GPS 95 will revert to the page
that you were on prior to scanning. The selected waypoint will be
displayed on the waypoint identifier field.
NOTE: When duplicate entries exist for the selected item (identifier/city/
facility name), the additional entries may be viewed by continuing to press
the arrow keys until the desired waypoint is selected.

3.11 REVIEWING WAYPOINTS

The GPS 95 allows you to quickly review waypoint information without
entering the waypoint identifier. For example, you may review information
regarding the waypoints in a route, or review the definition of the nearest
waypoints. In general, if the cursor is over a waypoint identifier, you may
quickly review the information about that waypoint.
To review a waypoint definition...
· Place the cursor over a waypoint identifier (using the arrow keys) and
press ENT. The Waypoint Definition Page is displayed indicating the
category of waypoint shown.
3-16