Electrical Connection - Baumatic BHC310 30cm Instruction Manual

o Fasten the bracket to the position on the hob with a screw.
Adjust the bracket position to suit different table top thicknesses.
o Place the long screw into the fixing hole on the outer edge of the
bracket but do not fully tighten.
o Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
o When the hob is correctly positioned, tighten the long screws to
fix the hob securely in the aperture hole. These screws MUST
be securely tightened.

Electrical connection

YOUR
PERMANENT INSTALLATION.
o Cable type: H05 RRF 3 core x 1.50 mm³ (Type RR-F <HAR>
marked). (not supplied)
o Before connecting the appliance, make sure that the supply
voltage marked on the rating plate corresponds with your mains
supply voltage.
o We recommend that the appliance is connected by a qualified
electrician, who is a member of the N.I.C.E.I.C. and who will
comply with the I.E.E. and local regulations.
o WARNING: THIS APPLIANCE MUST BE EARTHED.
o The hob must be wired into a 20A double pole switched fused
spur outlet, having 3 mm contact separation and placed in an
easily accessible position adjacent to the appliance. The spur
outlet must still be accessible even when your hob is located in
its housing.
o The wiring in the mains lead is coloured as follows:
Brown
Blue
Green and yellow
o As the colours of the wires in the appliance's mains lead may not
correspond with the coloured markings identifying the terminals
in your spur box, please proceed as follows:
HOB IS INTENDED
Live
Neutral
Earth
FOR FITTED AND
26