GE JKP20 Installation Instructions Manual page 11

Installation Instructions
To install a single metal bottom trim assembly (on some models), use sections C3 and C4.
To install a metal bottom trim with a plastic bottom trim (on some models), use sections C3-C5.
Preparing for the Bottom
Trim Installation
a. With oven installed, take the bottom trim
and center it on the bottom front edge of
the cabinet opening.
b. Using the trim
as a template,
mark the center
of each slot
(three total) where
the mounting holes
will be drilled.
c. Remove the trim.
d. Drill pilot holes into the
center of each template mark.
With Lower Trim
in Position, Mark
&_lllllt/I
(3) Mounting Hole _."_J I.HI
Locations -_>_
Before
Pre-drilling
Mounting
Holes
Installing the Metal
Bottom Trim
a. Place the bottom metal trim centered over
the pre-drilled mounting holes. Tape the
edges of the trim down to maintain the
alignment.
Side
_Trim
Trim Screws
Side /
Trim -_
Metal Lower Trim
b. Using three trim screws provided, secure
the bottom trim to the bottom edge of the
cabinet.
IMPORTANT: If this unit is ever
removed from the cabinet or the oven
is ever pulled out for service, the trim
must be removed first or damage to
the trim will occur.
Installing the Plastic Bottom
Trim
(on some models)
a. Make sure flat side is up on the plastic
bottom trim.
b. Find the key slot on the back of the trim.
Key Hole Slot and Wide Flange at Top
c. Match the key slot with the rivet on the
bottom of the side trim, and lower the trim
onto the rivet.
_!Trim Mounting Rivet
O! !d of Metal Lower Trim
d. Push the trim down, at both ends, until it
snaps into place.
Ends
_iT_maD OTn_ a t?:teh
_ CAUTION:
Be sure you
do not tip the oven forward
during installation or you may
bend the bottom trim. The bottom trim
provides an opening for cooling air to
enter the cabinet. This opening should
never be blocked.
11