Shaw HDDSR 600 User Manual page 61

This connection is illustrated in the following diagram:
If your home has an Ethernet wall jack near your TV, simply plug the cable in step 2 into the wall
jack. The other end of this cable must still be connected to your router or a network switch.
METHOD 2 – POWERLINE BRIDGE CONNECTION
If you are unable to run a direct line from your home router to your satellite receiver,
two (2) HomePlug powerline bridge units can be used to "bridge" the connection and
turn any electrical outlet in your home into a wired network jack.
In most cases, this is a plug-and-play solution and no configuration is required.
To setup a powerline bridge:
1) Connect an Ethernet cable between your home router and the first powerline
bridge.
2) Connect the first powerline bridge directly to a power outlet near your router.
Do not connect through a surge protector.
3) Connect an Ethernet cable between the DSR and second powerline bridge.
4) Connect the second powerline bridge directly to a power outlet near your Shaw
Direct satellite receiver. Do not connect through a surge protector.
A57