Table of Contents
Advertisement
In many cases, it may be easiest to "load" the full approach while still some distance away, enroute to the
destination airport. Later, if vectored to final, use the steps above to select 'Activate Vector-To-Final' — which
makes the inbound course to the FAF waypoint active.
Activating a previously loaded approach with vectors to final:
1) Press the PROC Key to display the Procedures Window.
2) Highlight 'ACTIVATE VECTOR-TO-FINAL' and press the ENT Key.
Loading and activating an approach using the MENU Key:
1) From the Approach Loading Page, press the MENU Key. The page menu is displayed with 'Load & Activate
Approach' highlighted.
2) Press the ENT Key. When GPS is not approved for the selected final approach course, the message 'NOT
APPROVED FOR GPS' is displayed. GPS provides guidance to the approach, but the HSI must to be switched to
a NAV receiver to fly the final course of the approach.
REMOVING AN APPROACH FROM THE ACTIVE FLIGHT PLAN
When plans change while flying IFR, approaches can be easily removed from the Active Flight Plan.
Removing an approach from the active flight plan:
1) Press the FPL Key to display the Active Flight Plan Page (MFD) or the Active Flight Plan Window (PFD)
2) Press the MENU Key, and highlight 'Remove Approach'.
3) Press the ENT Key. A confirmation window is displayed listing the approach procedure.
4) With 'OK' highlighted, press the ENT Key. To cancel the removal, highlight 'CANCEL' and press the ENT Key.
Or :
1) Press the FPL Key to display the Active Flight Plan Page (MFD) or the Active Flight Plan Window (PFD)
2) Press the FMS Knob, and turn to highlight the approach header in the active flight plan.
3) Press the CLR Key. A confirmation window is displayed listing the approach procedure.
4) With 'OK' highlighted, press the ENT Key. To cancel the removal, highlight 'CANCEL' and press the ENT Key.
5) Press the FMS Knob to remove the flashing cursor.
MISSED APPROACH
Activating a missed approach in the active flight plan:
Press the Go Around Button.
Or :
Fly past the MAP, and press the SUSP Softkey on the PFD.
Or :
1) Press the PROC Key.
2) Turn the FMS Knob to highlight 'ACTIVATE MISSED APPROACH'.
3) Press the ENT Key. The aircraft automatically sequences to the MAHP.
190-00595-01 Rev. B
Garmin G1000 Pilot's Guide for the Beechcraft A36/G36
FLIGHT MANAGEMENT
231
Advertisement
Table of Contents
