Table of Contents
Advertisement
TRAFFIC MAP PAGE
The Traffic Map Page is specialized to show surrounding TIS traffic data in relation to the aircraft' s current
position and altitude, without clutter from the basemap. Aircraft orientation on this map is always heading up
unless there is no valid heading. Map range is adjustable with the RANGE Knob from 2 to 12 nm, as indicated
by the map range rings.
The traffic mode is annunciated in the upper left corner of the Traffic Map Page. When the aircraft is on the
ground, TIS automatically enters Standby Mode. Once the aircraft is airborne, TIS switches from Standby to
Operating Mode and the G1000 begins to display traffic information. Refer to the System Status discussion for
more information.
Displaying traffic on the Traffic Map Page:
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the Traffic Map Page.
3) Confirm TIS is in Operating Mode:
Press the OPERATE Softkey to begin displaying traffic.
Or :
a) Press the MENU Key.
b) Select 'Operate Mode' (shown if TIS is in Standby Mode) and press the ENT Key.
"TIS Not Available"
Voice Alert Status
"Non-Bearing" Traffic
(System Unable to
Determine Bearing)
Distance is 8.0 nm,
1100' Above,
Descending
Traffic Advisory
400' Below,
Climbing
Traffic Status
Banner
190-00595-01 Rev. B
Traffic Mode Annunciation
Garmin G1000 Pilot's Guide for the Beechcraft A36/G36
Figure 6-60 Traffic Map Page
HAZARD AVOIDANCE
Non-Threat
Traffic
Range
Marking
Rings
Proximity
Advisory
1700'
Above,
Descending
Non-Threat
Traffic
Select
to Mute
"TIS Not
Available"
Voice Alert
315
Advertisement
Table of Contents
