Ident Function - Garmin Beechcraft A36 Pilot's Manual

AUDIO PANEL AND CNS
VFR CODE
The VFR code can be entered either manually or by pressing the XPDR Softkey, then the VFR Softkey.
When the VFR Softkey is pressed, the pre-programmed VFR code is automatically displayed in the code field
of the Transponder Data Box. Pressing the VFR Softkey again restores the previous identification code.
The pre-programmed VFR Code is set at the factory to 1200. If a VFR code change is required, contact a
Garmin-authorized service center for configuration.

IDENT FUNCTION

In Standby Mode, the IDENT Softkey is inoperative.
NOTE:
Pressing the IDENT Softkey sends an ID indication to Air Traffic Control (ATC). The ID return distinguishes
one transponder from all the others on the air traffic controller' s radar screen. The IDENT Softkey appears on
all levels of transponder softkeys. When the IDENT Softkey is pressed, a green IDNT indication is displayed in
the mode field of the Transponder Data Box for a duration of 18 seconds.
After the IDENT Softkey is pressed while in Mode or Code Selection, the system reverts to the top-level
softkeys.
Press the
IDENT Softkey
to Initiate the
ID Function
118
Figure 4-38 VFR Code
Figure 4-39 IDENT Softkey and Indication
Garmin G1000 Pilot's Guide for the Beechcraft A36/G36
VFR Code
IDNT
Indication
190-00595-01 Rev. B