General Screen - ZyXEL Communications NBG4604 User Manual

22.4 General Screen

Use this screen to select how you connect to the Internet.
Figure 122 Maintenance > Sys OP Mode > General
If you select Router Mode, the following pop-up message window appears.
Figure 123 Maintenance > Sys Op Mode > General: Router
• In this mode there are both LAN and WAN ports. The LAN Ethernet and WAN
Ethernet ports have different IP addresses.
• The DHCP server on your device is enabled and allocates IP addresses to other
devices on your local network.
• The LAN IP address of the device on the local network is set to 192.168.1.1.
• You can configure the IP address settings on your WAN port. Contact your ISP or
system administrator for more information on appropriate settings.
If you select Access Point the following pop-up message window appears.
Figure 124 Maintenance > Sys Op Mode > General: AP
• In AP Mode all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port labeled
WAN. There is no WAN port.
• The DHCP server on your device is disabled. In AP mode there must be a device
with a DHCP server on your network such as a router or gateway which can
allocate IP addresses.
The IP address of the device on the local network is set to 192.168.1.2.
NBG4604 User's Guide
Chapter 22 Sys OP Mode
197