Switching The Wireless Components On And Off; Wlan And Bluetooth; Gps - Fujitsu Stylistic M532 User Manual

Removing a memory card
It is very important that the correct procedure be used for removing
the memory card. Failure to do so could result in data loss.
To remove a MicroSD card, you must log the memory card out of the
system before you can remove it. Proceed as follows:
Settings > Memory
Select
1
are displayed.
Remove SD card
Select
2
Confirm the message with
3
Press the memory card slightly inwards so that the catch
4
disengages.
Pull the memory card out of the slot (Figure 10, #1).
5
Replace the slot cover (Figure 10, #2)10
6

Switching the wireless components on and off

WLAN and Bluetooth

Settings
Select .
1
Set the switch for WLAN or Bluetooth to ON.
2
Click on WLAN and select your preferred network.
3
Bluetooth
Click on and select the Bluetooth device with which you would like to connect your tablet.
4

GPS

Your device is equipped with an integrated GPS module. With the aid of suitable software, you can therefore use
your device as a navigation system.
Memory
. In , all the memory components
.
OK
. The memory card is logged out.
24 - Switching the wireless components on and off
2
1
Figure 10. Removing a MicroSD Card