Removing The Sim Card; Wireless Lan / Bluetooth / Umts / Lte / Nfc Wireless Components; Configuration); Switching The Wireless Components On And Off - Fujitsu Q616 Operating Manual

Working with the Tablet PC

Removing the SIM card

1
2
3
Wireless LAN / Bluetooth / UMTS / LTE / NFC wireless
components (depending on configuration)
The installation of wireless components not approved by Fujitsu will
invalidate the certifications issued for this device.

Switching the wireless components on and off

wireless components are switched on and off via the corresponding functions of the operating system.
► To switch wireless components on and off individually, select Settings – Change
PC settings – Network – Airplane mode.

Setting up WLAN access

• Requirement: A WLAN must be available and you must have the
corresponding access information.
Information on configuring the WLAN access can be found in the
documentation for your operating system.
NFC (Near Field Communication, depending on configuration)
Depending on the configuration chosen, your Tablet PC may be equipped with an
integrated NFC chip. Near field communication is used for contact-free data exchange by
wireless transmission over short distances (a few centimetres).
34
4
► Open the slot cover (1).
► Pull the SIM card holder out of the slot (2).
► Remove the SIM card from the SIM
card holder (3).
► Push the SIM card holder back
into the slot (4).
► Close the slot cover.
Fujitsu