Fetco CBS-2131 User Manual page 7

Final Setup
1. Turn on incoming water supply line and carefully inspect both inside and
outside of the brewer for leaks in all fittings and tubes
2. Turn on power.
3. Press the brewer's main power switch (located on the lower right of the
back of the equipment)
4. Pre-check will display: "DC voltage calibration for pumps is
running...Please wait...Calibration is successfully done". (15 seconds)
5. The water tank will begin filling. FETCO Home Screen #1 will read
"FILLING".
6. When the water level rises and is sensed by the probe at the top of the
tank the heaters will activate
7. Heaters are automatically disabled until the tank is full.
8. While the water is heating Screen #2 "HEATING" will display and the
actual water temperature will be displayed.
9. After the water has reached the set temperature Screen #3 will display
"READY"
10. Review the Operating Instructions. Brew one full batch (water only) on
each side to confirm proper fill levels. The brewer is factory set with water
only (no coffee) to dispense the correct amount of water. If the actual
volume is slightly different from the programmed volume, fine tuning the
brewer may be necessary. See Calibrate Pumps in the OUTPUT section
in the PROGRAMMING section.
11. Re-attach the covers after one final inspection for leaks. Look closely in
the top of the brewer section at the dispense fittings during this
inspection.
Final Setup
Features of your FETCO Brewer
Touch-screen for brewer operation
Brew basket sensor (not accessible)
SD card interface port (Load & Save)
Locator removable for service access
Locator for airpot dispenser
Slide out back panel for service access
FETCO Home Screen #2 "HEATING"
Hot Water Faucet
(Two for CBS-2132)
Main power switch
7
FETCO Home Screen #1 "FILLING"
FETCO Home Screen #3 "READY