Configuration (Standalone); Sound-Active Mode; Automatic Mode; Manual Pan/Tilt Operation - Chauvet Intimidator Spot LED 350 User Manual

Configuration
(Standalone)
Sound-Active
Mode

Automatic Mode

Manual Pan/Tilt
Operation
Pan/Tilt Angle
Range

Display

Intimidator™ Spot LED 350 User Manual (Rev. 6)
Set the product in one of the standalone modes to control without a DMX controller.
1. Connect the product to power.
2. Turn the product on.
Never connect a product that is operating in any standalone mode (either
Automatic or Sound-Active) to a DMX string connected to a DMX controller.
Products in standalone mode may transmit DMX signals that could interfere with
the DMX signals from the controller.
To enable the Sound-Active mode, do the following.
1. Press <MODE/ESC> repeatedly until one of the following shows on the display:
NASl, NAFA, NStS, SLAv
2. Press <UP> or <DOWN> to select NStS.
3. Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To enable the Automatic mode:
1. Press <MODE/ESC> repeatedly until one of the following shows on the display:
NASl, NAFA, NStS, SLAv
2. Press <UP> or <DOWN> to select NASl (for a slow light show) or NAFA (for a fast
light show).
3. Press <ENTER>.
To select whether you want the Intimidator™ Spot LED 350 to operate with normal
panning or inverted panning, do the following.
1. Press <MODE/ESC> repeatedly until PAn shows on the display.
2. Press <UP> or <DOWN> to select normal pan operation (PAn) or inverse pan
operation (r PAn).
3. Press <ENTER>.
To select whether you want the Intimidator™ Spot LED 350 to operate with normal tilting
or inverted tilting, do the following:
1. Press <MODE/ESC> repeatedly until tiL shows on the display.
2. Press <UP> or <DOWN> to select normal pan operation (tiL) or inverse pan
operation (r tiL).
3. Press <ENTER>.
You are able to select the range for the pan and tilt angles on the Intimidator™ Spot
LED 350 to achieve the effect you like.
To select which pan angle range to use, do the following.
1. Press <MODE/ESC> repeatedly until PA54 shows on the display.
2. Press <UP> or <DOWN> to select 540° (PA54), 360° (PA36), or 180° (PA18).
3. Press <ENTER>.
To select which tilt angle range to use, do the following.
1. Press <MODE/ESC> repeatedly until Ti27 shows on the display.
2. Press <UP> or <DOWN> to select 270° (Ti27), 180° (Ti18), or 90° (Ti 9).
3. Press <ENTER>.
You are able to flip the LED display for easy readability in any mounting situation.
To select your display angle:
1. Press <MODE/ESC> repeatedly until diS shows on the display.
2. Press <UP> or <DOWN> to select normal display mode (diS) or inverse display
mode (r diS).
3. Press <ENTER>.
Page 15 of 20