Back to Contents Page
Antenna-In Connector
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the Antenna-In Connector
Replacing the Antenna-In Connector
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the Antenna-In Connector
1. Follow the instructions in
Before You
2. Remove the back cover (see
3. Follow the instructions from
4. Follow the instructions from
5. Remove the hex nut that secures the antenna-in connector to the system-board shield.
6. Release the antenna-in connector from the slot on the system-board shield.
7. Lift the antenna-in connector along with its cable away from the system-board shield.
1
antenna-in connector
Replacing the Antenna-In Connector
1. Follow the instructions in
Before You
2. Slide the antenna-in connector into the slot on the system-board shield.
3. Replace the hex nut that secures the antenna-in connector to the system-board shield.
4. Follow the instructions from
5. Follow the instructions from
Begin.
Removing the Back
Cover).
step 2
to
step 5
in
Removing the Front
step 4
to
step 8
in
Removing the System-Board
2
hex nut
Begin.
step 4
to
step 8
in
Replacing the System-Board
step 4
to
step 5
in
Replacing the Front
Stand.
Shield.
Shield.
Stand.