Clearing Cmos Passwords - Dell XPS L701X Service Manual

Hide thumbs Also See for XPS L701X:
Table of Contents

Advertisement

 
6. Wait for approximately five seconds to clear the password setting.
 
7. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.
 
8. Replace the system-board shield (see
 
9. Replace the back cover (see
 
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
 
10. Connect your computer and devices to electrical outlets, and turn them on.
 Clearing CMOS Passwords
WARNING:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
WARNING:
The computer must be disconnected from the electrical outlet to clear the CMOS setting.
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ 
is not covered by your warranty.
 
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
 
1. Follow the instructions in
Before You
 
2. Remove the back cover (see
 
3. Remove the system-board shield (see
 
4. Locate the 3-pin CMOS reset jumper (CLR_CMOS) on the system board. (see
 
5. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
Inspiron One 2305
Replacing the System-Board
Replacing the Back
Cover).
Begin.
Removing the Back
Cover).
Removing the System-Board
Shield).
Shield).
System Board
Components).

Advertisement

Table of Contents
loading

Table of Contents