Removing The Palm-Rest Assembly - Dell XPS L701X Service Manual

Back to Contents Page
Palm-Rest Assembly
Dell™ XPS™ L701X Service Manual
Removing the Palm-Rest Assembly
Replacing the Palm-Rest Assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Palm-Rest Assembly
1. Follow the instructions in Before You
2. Remove the battery (see Removing the
3. Remove the module cover (see
4. Remove the memory module(s) (see
5. Follow the instructions in step 5
6. Remove the optical drive (see
7. Remove the three screws that secure the palm-rest assembly to the base cover.
8. Turn the computer over and open the display as far as possible.
9. Using your fingertip, gently push the tab to release the palm-rest assembly from the top cover.
Begin.
Battery).
Removing the Module Cover).
Removing the Memory Module(s)).
in Removing the Hard Drive(s).
Removing the Optical Drive).
Removing the Battery) before working inside the