Dell XPS L701X Service Manual page 67

Back to Contents Page
Infrared Blaster Connector
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the Infrared (IR) Blaster Connector
Replacing the Infrared (IR) Blaster Connector
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the Infrared (IR) Blaster Connector
1. Follow the instructions in Before You
2. Remove the back cover (see
3. Follow the instructions from
4. Follow the instructions from
5. Remove the nut that secures the infrared (IR) blaster to the system-board shield.
6. Release the IR blaster connector from the slot on the system-board shield.
7. Lift the IR blaster connector along with its cable away from the system-board shield.
1 IR blaster connector
Replacing the Infrared (IR) Blaster Connector
1. Follow the instructions in Before You
2. Slide the IR blaster connector into the slot on the system-board shield.
3. Replace the nut that secures the IR blaster connector to the system-board shield.
4. Follow the instructions from
5. Follow the instructions from
6. Replace the back cover (see
Begin.
Removing the Back Cover).
step 2 to step 5 in Removing the Front
step 4 to step 8 in Removing the System-Board
2 nut
Begin.
step 4 to step 8 in Replacing the System-Board
step 4 to step 5 in Replacing the Front
Replacing the Back Cover).
Stand.
Shield.
Shield.
Stand.