6. Replace the processor module (see
7. Replace the heat sink (see
Replacing the Heat
8. Follow the instructions from
9. Slide the USB-board cable into the system-board connector and press down on the connector latch to secure the cable.
10. Replace the coin-cell battery (see
11. Replace the bluetooth card (see
12. Replace the Mini-Card(s) (see
13. Replace the display assembly (see
14. Replace the keyboard (see
15. Replace the palm-rest assembly (see
16. Replace the optical drive (see
17. Follow the instructions in
step 5
18. Replace the memory module(s) (see
19. Replace the module cover (see
20. Replace the battery (see
Replacing the
21. Replace any blank or card you removed from the Media Card Reader.
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
22. Turn on the computer.
NOTE:
After you have replaced the system board, enter the computer Service Tag into the BIOS of the replacement system board.
23. Enter the service tag (see
Entering the Service Tag in the
Entering the Service Tag in the BIOS
1. Ensure that the AC adapter is plugged in and that the main battery is installed properly.
2. Turn on the computer.
3. Press <F2> during POST to enter the system setup program.
4. Navigate to the security tab and enter the service tag in the Set Service Tag field.
Back to Contents Page
Replacing the Processor
Module).
Sink).
step 11
to
step 15
in
Replacing the Top
Replacing the Coin-Cell
Battery).
Replacing the Bluetooth
Card).
Replacing the
Mini-Card(s)).
Replacing the Display
Assembly).
Replacing the
Keyboard).
Replacing the Palm-Rest
Replacing the Optical
Drive).
in
Replacing the Hard
Drive(s).
Replacing the Memory
Module(s)).
Replacing the Module
Cover).
Battery).
BIOS).
Cover.
Assembly).