Front Pe (Paper End) Detector; Rear Pe Detector - Epson 890N - FX B/W Dot-matrix Printer Service Manual

EPSON FX-890/2190

4.3.10 Front PE (Paper End) Detector

1. Remove the Printer Mechanism. (p.80)
2. Release the 2 clips attaching the front PE detector to the Rear Paper Guide
Assembly, and remove the detector. (See Figure 4-24)
3. Disconnect the harness from the detector.
Front PE
Detector
Clips
Figure 4-24. Front PE Detector Removal
Disassembly and Assembly
Harness
Rear Paper Guide
Assembly
Printer Mechanism Disassembly

4.3.11 Rear PE Detector

1. Remove the Printer Mechanism. (p.80)
2. Hold the Printer Mechanism horizontally.
3. Release the 2 clips securing Rear PE detector to Rear Paper Guide Assembly.
4. Release the 2 notches on the Rear Paper Guide Assembly securing the detector,
and slide the detector toward rear a little. Then remove the detector by pulling it
downward. (See Figure 4-25)
5. Disconnect the harness from the detector.
Rear PE Detector
1
Figure 4-25. Rear PE Detector Removal
Revision B
Harness
2
1
87