Air Conditioner Use; Starting Your Air Conditioner - Whirlpool Room Air Conditioners for Slider & Casement Windows Use And Care Manual

AIR CONDITIONER U SE
Operating your air conditioner properly helps you to obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
• If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 66°F (19°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTES:
• In the event of a power failure, your air conditioner will
automatically turn back on.
If the electronic control will not respond to touch pad or
remote control commands, it is necessary to unplug the air
conditioner from the electrical outlet for 5 seconds before
plugging back in.
Closed Open TEMP
FAN SPEED m
AIR EXCHANGER Q _, _I_ _ ,_ _ Q
TIMER MODE
NOTE: If the room temperature is below 55°F (13°C), the display
will show 55°F (13°C). If the room temperature is above 99°F
(37°C), the display will show 99°F (37°C).
1. Remove clear protective film from control panel and front
panel badge.
2. Set air exchanger. See "Air Exchanger."
3. Press POWER to turn on air conditioner.
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool
mode, Turbo fan speed, 72°F (22°C) for 3 seconds. When it is
turned on at all other times, it will display the previous
settings for 3 seconds, and then display the room
temperature.
4. Choose mode. See "Mode."
5. Choose fan speed. See "Fan Speed."
6. Choose temperature. See "Temperature."
Air Exchanger
Set the Air Exchanger control to CLOSED for maximum
continuous cooling. The Air Exchanger set to OPEN circulates
fresh air and draws stale or smoky air from the room.
• Open--to exhaust room air to the outside
• Closed--maximum air circulation and cooling
Closed Open
AirExchanger
Display Symbols
E F
A. Cool mode indicator light
B. Fan only mode indicator light
C. Power Saver indicator light
D. Timer indicator light
B C D
,,,%
G H
E Auto fan mode indicator fight
E Low fan mode indicator light
G. High fan mode indicator fight
H. Turbo fan mode indicator light
Mode
1,
2.
Press MODE until you see the indicator light come on for the
setting you desire.
Choose Cool, Fan Only or Power Saver.
• Cool--Cools room. Press FAN SPEED to choose fan
speed. Then adjust the temperature by pressing the plus
or minus buttons.
• Fan Only--Only the fan runs. You can select the fan
speed by pressing FAN SPEED, but you cannot adjust the
Temperature control setting. Display shows the current
room temperature.
• Power Saver--Fan runs only when cooling is needed. You
can select the fan speed by pressing FAN SPEED.
Because the fan does not circulate the room air
continuously, less energy is used, but the room air is not
circulated as often. Use Power Saver when you are
asleep or away from home.
©
MODE