Whirlpool Room Air Conditioners for Slider & Casement Windows Use And Care Manual page 6

3=
4.
"' E
L ................................................. F
A. _6" machine screws D. Nut
B. Support plate E. Support angle
C. Flat washer F. Levering bolt and Iocknut
Place support platform against lower window track and firmly
against vertical edge of window frame.
Attach support platform to windowsill using two 1" wood
screws.
If required, overcome interference of support platform with
window track or storm windows by securely attaching a shim
strip to the windowsill. Shim strip should be as long as width
of support platform and flush with back edge of sill.
Thickness of shim strip should be controlled by amount of
interference.
A .................................................................... ............
C
D
5=
6.
7=
A. 1" wood screws D. Windowsill
B. Support plate E. Shim strip
C. Lower window track
Pull support angle against outside of structure. Tighten two
7A6"machine screws on top of support platform.
Adjust leveling bolt to level support angle. Tighten leveling
bolt Iocknut.
NOTE: Air conditioner must be level or tilted back slightly to
facilitate proper condensate disposal.
Cut two pieces of seal to height of window opening. Remove
backing and apply to window frame and sliding sash that will
rest against air conditioner cabinet.
Install air conditioner in window
2=
Slide air conditioner onto support platform. Check to be sure
air conditioner side channel fits securely against vertical edge
of window frame.
NOTE: If air conditioner side channel does not fit securely
against window frame, remove air conditioner and readjust
leveling bolt.
Drill two 1/8"holes through the window channel frame in
alignment with existing holes in bottom bracket. Install two
%" self-tapping screws through these holes.
NOTE: If window channel frame is not tall enough to use
existing holes, drill two new holes off to the side of the
existing holes to attach the air conditioner bottom bracket to
the support platform. Air conditioner should be firmly
anchored to window channel frame or support platform.
A .........................................
III .......
/
A. Window channel frame
B. %" self-tapping screw
_.................. B
............... C
I¸¸¸¸ . ............................ O
C. Bottom bracket
D. _" drilled hole
3. Slide inside window sash closed. Check to be sure vertical
edge of inside window sash is pressed firmly against side of
air conditioner cabinet. Cut remaining seal to width of
window opening. Remove backing and apply to top inside
edge of window frame.
4. Install speed clips on top and bottom inside edge of window
to provide locking.
5. Using supplied plastic seal, cut to proper length, insert
between inside window sash and outside window.
A. Speed clip
B. Window channel
C. Plastic seal
6. See "Complete Installation."