Removing The Coin-Cell Battery; Replacing The Coin-Cell Battery - Dell Vostro A840 Service Manual

Back to Contents Page
Coin-Cell Battery
Dell™ Vostro™ A840/A860 Service Manual
Removing the Coin-Cell Battery
Replacing the Coin-Cell Battery
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
Removing the Coin-Cell Battery
1. Follow the instructions in Before You
2. Remove the system board (see
3. Turn the system board over.
4. Disconnect the coin-cell battery cable from the system board connector.
5. Remove the coin-cell battery out of the mylar sleeve.
1 coin-cell battery 2 coin-cell battery cable connector
Replacing the Coin-Cell Battery
1. Replace the coin cell battery in the mylar sleeve.
2. Connect the coin-cell battery cable to the system board connector.
3. Follow the instructions in Replacing the System
4. Slide the main battery into the battery bay, until it clicks into place.
Back to Contents Page
Begin.
Removing the System Board).
Board.