Ink Installation; ‘Plug And Play Cartridge’ Characteristics; Installing Ink Into Reservoirs; Attach Septum Fitting To Valve Body - Kodak NOVAJET 750 Training Manual

A. Ink Installation
1. 'Plug and Play Cartridge' characteristics
Do not break connection when installing
new cartridge
25 ml inside
2.

Installing ink into reservoirs

It is suggested to fill reservoirs over a table to prevent spills on printer; fill to a
maximum of 400 ml (50 ml minimum).
3. Attach septum fitting to valve body. Prime line (and cartridge if
necessary).
NOTE: When the valve body is raised to the up
position ink flow is cut off, when the valve body (latch)
is closed then the ink line is open.
Installed needle assembly
preprimed
-
NJ750 Training Guide
2