8-4. ERROR DISPLAY.
I WD-1223(5)F(H)(B)/WD-1243(5)F(H)(B)/WD-102(4)1(5)WF(H) / WD-1041(3)F(H)B
If you press the Start/Pause
will disappear and the machine will change into pause status.
In case of
if the error is not resolved within 4 min. power will be turned off automatically and the error code will blink.
button when an error in displayed, any error except
Water has not reached to the pre-set level within 4 min. since
inlet valve operated, or water has not reached to the normal
level within 25 min.
The appliance is tilted.
Laundry is gathered to one side.
Non-distributable things are put into the drum.
Water has not drained enough within 5 min.
Water is automatically being pumped out because too much
water is in the tub.
The sensor pressure switch is out of order.
The door switch is out of order.
The thermistor is out of order.
The connector (5-pin, male, white) in the wire harness is not
connected to the connector (5-pin, female) of hall sensor in
' Reconnect or repair the contact in the connector.
if the error is not resolved within 20 sec. In the case of other
button is pressed with the door open.