Reset - ATEN CS1708i User Manual

Manual
If Automatic synching isn't able to keep the pointers in sync, selecting Manual
provides you with a number of methods to bring them back into sync:
Perform a video and mouse auto sync by clicking the Video Settings icon
on the Control Panel (see page 77).
Perform an Auto Sync with the Video Adjustment function (see The
Control Panel, page 77).
Invoke the Adjust Mouse function with the Adjust Mouse hotkeys (see
Adjust mouse, page 79, for details).
Move the pointer into all 4 corners of the screen (in any order).
Note: If you continue to have sync problems, you should set the mouse speed
and acceleration settings on each problematic server. See Additional
Mouse Synchronization Procedures, page 149, for instructions.

Reset

The functions performed by these parameters are explained in the table, below:
Parameter
Reset on Exit
Reset Default
Values
Clear Port Names
Place a check here to have the switch reset itself and implement
all the new settings when you log out. Following the reset, wait
approximately 30 to 60 seconds before logging back in.
For network IP address settings changes the check box is
automatically selected and the switch will reset when you log out.
Clearing the check mark before logging out will cause the new IP
settings to be ignored and the original IP address settings will
remain in effect.
Note: Even though the new IP information is ignored, it still
remains in the field. Therefore, the next time you log in the
checkbox will be selected and the next time that the switch resets
the IP settings that you thought you discarded will be saved. To
avoid this problem, you should be sure that the IP settings that
appear in the field are the ones you want to save.
This function undoes all changes that have been made to the
switch (except for the Port Names), and returns the parameters to
their original factory default settings.
This function removes the names that have been assigned to the
ports settings (see Port Names, page 88).
Explanation
6. Administration
71