CS1708i / CS1716i User Manual
F7: SCAN
This function (also referred to as Auto Scan Mode) allows you to automatically
switch the KVM focus among the available computers at regular intervals so
that you can monitor their activity without having to take the trouble of
switching manually.
The selection of computers to be included for auto scanning is made with
the Scan–Skip mode setting under the F3: SET function (see SCAN–SKIP
MODE, page 33).
The amount of time that each port displays for is set with the Scan
Duration setting under the F3: SET function (see SCAN DURATION,
page 32). When you want to stop at a particular location, press [Space] to
stop scanning and exit Auto Scan Mode.
If the scanning stops on an empty port, or one where the computer is
attached but is powered Off, the monitor screen will be blank, and the
mouse and keyboard will have no effect. Simply wait - after the Scan
Duration time is up, the Scan function will move on to the next port.
As each computer is accessed, an S appears in front of the Port ID display
to indicate that it is being accessed under Auto Scan Mode.
While Auto Scan Mode is in effect, the console will not function normally.
You must exit Auto Scan Mode in order to regain control of the console.
While you are in Auto Scan Mode, you can pause the scanning in order to
keep the focus on a particular computer either by pressing P, or with a left-
click of the mouse. See Auto Scan Mode, page 43, for details.
To exit Auto Scan Mode, press the [Space] or [Esc].
38