Step 5. Stopping The Diagnostics - IBM RS/6000 44P Series User Manual

Step 5. Stopping the Diagnostics

1. If you are running Online diagnostics, shut down the system using the following
procedure:
a. Press F3 repeatedly until you get to the Diagnostic Operating Instructions, then
b. Press F3 once, and then follow the displayed instructions to shut down the
2. If you changed any attributes on your ASCII terminal to run the diagnostics, change
the settings back to normal.
3. This completes the system verification. Report the SRN, if you received one, to the
service organization. To do a normal boot, turn off the system unit and wait 30
seconds, and then set the power switch of the system unit to On.
follow the displayed instructions.
system.
Chapter 7. Using the System Verification Procedure
147