Utilities; Set Password And Unattended Start Mode - IBM RS/6000 44P Series User Manual

Configure Nth Boot Device
Device
Number
1
2
3
4
5
===>
Type the device number of the device name that you want to select as the Nth boot
device. For example, if you entered this menu by selecting 4 on the previous menu
(configure 2nd Boot Device), then enter the number 3 based on the list shown above.
You are thus selecting the SCSI CD-ROM device to be the 2nd (Nth) device in the boot
sequence.

Utilities

The Utilities screen enables you to select from the following system management tools.
Utilities
1 Set Passwords and Unattended Start Mode
2 SCSI Spin up
3 Display Error Log
4 Remote Initial Program Load Setup
5 Change SCSI id
6 Update System Firmware
7 Update Service Processor Firmware
8 Select Console
===>

Set Password and Unattended Start Mode

Entering this selection permits access to the following options.
98
44P Series Model 170 User's Guide
Current Device
Position Name
1 Diskette
2 Ethernet
3 SCSI CD-ROM
4 SCSI 4.5GB Hard Disk
-
.------.
|X=Exit|
'------'
.------.
|X=Exit|
'------'