Connecting System Components; Summary; Workflow For Connecting System Components In The Lustre Workgroup - HP XW8400 Manual

Summary

Workflow for Connecting System Components in the Lustre Workgroup

Connecting the Autodesk Control Surface
Assigning an IP Address to the Autodesk Control Surface
Configuring Lustre to Connect to the Autodesk Control Surface
Connecting a Stand-Alone Tablet
Connecting the Slave Renderer to a Lustre Workstation
Connecting Video I/O to a Master or HD Station
Setting Up VTR Emulation
Connecting to a High-Speed Data Link Device (HSDL)
Connecting Audio Hardware
Workflow for Connecting System Components in the Lustre
Workgroup
After you have connected peripherals to your workstation, you are ready to connect it to the
Autodesk control surface, to video I/O hardware, and to a Slave Renderer.
See the following table for a summary of the steps necessary to connect components in your
workgroup.
Step:
1. Connect the control surface to your
workstation.
2. If necessary, connect a tablet to your
workstation.

Connecting System Components

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
Refer to:
For the Autodesk control surface:
the Autodesk Control Surface"
"Assigning an IP Address to the Autodesk Control
Surface"
Connect to the Autodesk Control Surface"
page 33.
"Connecting a Stand-Alone Tablet"
. . . . 27
. . . . . . . . . . . . . . . . . . . 31
. . . . . . . . . . . . 33
. . . . . . . . . . . . . . . . . . . . 33
. . . . . . . . . . . . . . . . . . . . . . . . . . . 36
. . . . . . . . . . . . . . . . . . . . . 39
on page 31, and "Configuring Lustre to
"Connecting
on page 28,
on
on page 33.
27