Table of Contents
Advertisement
Summary
Workflow for Connecting System Components in the Lustre Workgroup
Connecting the Autodesk Control Surface
Assigning an IP Address to the Autodesk Control Surface
Configuring Lustre to Connect to the Autodesk Control Surface
Connecting a Stand-Alone Tablet
Connecting the Slave Renderer to a Lustre Workstation
Connecting Video I/O to a Master or HD Station
Connecting to a High-Speed Data Link Device (HSDL)
Workflow for Connecting System Components in the Lustre
Workgroup
After you have connected peripherals to your workstation, you are ready to connect it to the
Autodesk control surface, to video I/O hardware, and to a Slave Renderer.
See the following table for a summary of the steps necessary to connect components in your
workgroup.
Step:
1. Connect the control surface to your
workstation.
2. If necessary, connect a tablet to your
workstation.
3. Connect a Slave Renderer to the Lustre
workstation (Windows only).
Connecting System Components
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
Refer to:
For the Autodesk control surface:
the Autodesk Control Surface"
"Assigning an IP Address to the Autodesk Control
Surface"
Connect to the Autodesk Control Surface"
page 27.
"Connecting a Stand-Alone Tablet"
"Connecting the Slave Renderer to a Lustre
Workstation"
. . . . 21
. . . . . . . . . . . . . . . . . . . 25
. . . . . . . . . . . . 27
. . . . . . . . . . . . . . . . . . . . 28
. . . . . . . . . . . . . . . . . . . . . . . . . . . 30
. . . . . . . . . . . . . . . . . . . . . 32
on page 25, and
"Configuring Lustre to
on page 28.
"Connecting
on page 22,
on
on page 27.
21
Advertisement
Table of Contents
