HP XW8400 Manual page 49

Adjusting Lucid ADA 88192 Converter Settings
You configure the converter through a series of setup menus that appear in the display on the
front of the converter. Use the encoder dial and button immediately to the right of the display to
navigate these menus and adjust settings.
The top level setup menu contains the following menu items: ADAT, AES, Analog, Meter, Route,
Sync, and System. Each of these menu items takes you into a submenu, from which you can
select and adjust settings.
The procedures below provide basic information on navigating and adjusting settings. If you
require additional information, refer to the Lucid ADA 88192 manual included with your
shipment.
To navigate menus and adjust settings:
Use the encoder dial and the button as follows.
1.
To:
Select a menu option Rotate the dial to highlight the option, then press the dial to select
Back up one level in
the menu tree
Navigate to the top
level setup menu
2. Make sure Lucid's AES inputs are routed to both AES and analog outputs.
To reset all settings to their factory defaults:
1. In the top level setup menu, select System, then select Miscellany.
2. In the Miscellany menu, select Defaults: RESET.
All settings are reset to their factory defaults.
N :
The factory default for the items in the AES setup menu is SRC ON. Local control requires
OTE
these items to be set to SRC OFF. If you reset to defaults, be sure to manually set these items
back to OFF.
Lucid ADA 88192 Converter Settings for Local Control
You must configure the following settings to control the converter locally. Any setting not listed
here either has no effect with the application or can be set to any of the values available for it.
Do this:
that option. If the option you select has choices (as, for example, in
the Route menu), rotate the dial again to move through the choices,
and press the dial to select an option.
Press the button.
Press the button. Repeat until you are in the top level setup menu.
Connecting Audio Hardware
43