HP XW8400 Manual page 16

1 Introduction
System ROM Flash was successful appears.
Verify system BIOS settings. See
14.
From the File menu, select Save Changes and Exit.
15.
Verifying BIOS Settings
You do not normally need to adjust BIOS settings on your workstation. BIOS settings for the
workstation are provided here for informational purposes only.
To enter the system BIOS, press F10 while booting the workstation.
W :
Before installing Red Hat® Linux, it is recommended that you verify the workstation's
ARNING
BIOS settings. If the storage SATA emulation option is not set correctly (to Separate IDE Controller),
you must redo Red Hat Linux installation.
The following table lists the proper Autodesk certified BIOS settings. Items not listed are set to
their default factory settings.
BIOS Menu
Storage, Storage options
Storage
Storage, Power, OS Power Management
Storage, Power, OS Power Management
Storage, Power, OS Power Management
Storage, Advanced, Device Options
Advanced
Restoring BIOS to Default Factory Settings
The following procedure restores the default factory BIOS settings.
To restore default factory BIOS settings:
Press F10 while booting the workstation to enter the system BIOS.
1.
From the File menu select Default setup | Restore Factory Settings as
2.
Default.
10
"Verifying BIOS Settings"
Item
SATA Emulation
Boot Order
Runtime Power
Management
Idle Power Savings
ACPI S3 Support
S5 Wake on LAN
Slot5 - PCI 133
on page 10.
Value
Separate IDE
Controller
Optical Drive
USB Device
Hard Drive,
Integrated SATA
Hard Drive,
Integrated IDE
Disabled
Normal
Disabled
Disabled
Slot5 speed 100Mhz
PCI-x m1