Coolant - Yamaha VINO XC50W Owner's Manual

Coolant<IXE>

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
The coolant level should be checked as
follows before each ride. In addition, the
coolant must be changed at the inter-
vals specified in the periodic mainte-
nance and lubrication chart.
1. Place the vehicle
centerstand.
NOTE:
8 The coolant level must be checked
on a cold engine since the level
varies with engine temperature.
8 Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Check the coolant level in the cool-
ant reservoir.
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU20070
NOTE:
The coolant should be between the mini-
mum and maximum level marks.
EAUT1521
on the
ZAUM00**
1. Maximum level mark
2. Minimum level mark
ZAUM00**
1. Coolant reservoir cap
1
2
1
6-11
3. If the coolant is at or below the mini-
mum level mark, remove panel A
and the reservoir cap. (See page 6-
6.)
4. Add coolant or distilled water to
raise the coolant to the maximum
level mark, and install the coolant
reservoir cap and the panel.
Coolant reservoir capacity (up to the
maximum level mark):
0.25 L (0.26 US qt) (0.22 Imp.qt)
cC
8 8 8 8 8 If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water
or salt water since it is harmful
to the engine.
8 8 8 8 8 If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the engine may not be suf-
ficiently cooled and the cooling
system will not be protected
against frost and corrosion.
8 8 8 8 8 If water has been added to the
coolant, have a Yamaha dealer
1
2
3
4
ECA10470
5
6
7
8
9