Coolant - Yamaha Zuma YW50FE 2014 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
2
3
1. Final transmission oil fi ller bolt
2. Final transmission oil drain bolt
4
4. Remove the oil fi ller bolt and drain
bolt to drain the oil from the fi nal
5
transmission case.
5. Install the final transmission oil
drain bolt, and then tighten it to
6
the specifi ed torque.
7
Tightening torque:
Final transmission oil drain bolt:
13 Nm (1.3 m·kgf, 9.4 ft·lbf)
8
6. Refill with the specified amount
9
of the recommended final trans-
mission oil, and then install the
oil filler bolt and tighten it to the
specified torque. WARNING!
Make sure that no foreign ma-
terial enters the fi nal transmis-
sion case. Make sure that no oil
1
gets on the tire or wheel.
Tightening torque:
Final transmission oil fi ller bolt:
23 Nm (2.3 m·kgf, 16.6 ft·lbf)
Recommended final transmission
oil:
See page 8-1.
Oil quantity:
0.10 L (0.11 US qt, 0.08 Imp.qt)
7. Check the fi nal transmission case
for oil leakage. If oil is leaking,
check for the cause.

Coolant

The coolant level should be checked
[EWA11311]
before each ride. In addition, the cool-
ant must be changed at the intervals
specifi ed in the periodic maintenance
and lubrication chart.
To check the coolant level
The coolant level should be checked
as follows before each ride. In addi-
tion, the coolant must be changed at
the intervals specified in the periodic
maintenance and lubrication chart.
1. Place the vehicle on the center-
TIP
●
●
6-13
stand.
T h e c o o l a n t l e v e l m u s t b e
checked on a cold engine since
the level varies with engine tem-
perature.
Make sure that the vehicle is po-
sitioned straight up when check-
ing the coolant level. A slight tilt
to the side can result in a false
reading.
EAU1722A
EAU20070
EAUT1523