Coolant - Yamaha LEXI Owner's Manual

Periodic maintenance and adjustment

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on the center-
stand.
TIP
 The
coolant
checked on a cold engine since
the level varies with engine tem-
perature.
 Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
9
side can result in a false reading.
2. Check the coolant level through
the check window.
TIP
The coolant should be between the
minimum and maximum level marks.
EAU20071
EAUN2170
1. Coolant level check window
2. Maximum level mark
3. Minimum level mark
level must be 3. If the coolant is at or below the
minimum level mark, remove the
right floorboard mat by pulling it
up.
1. Floorboard mat
4. Remove the coolant reservoir cov-
2
3
1
1. Coolant reservoir cover
5. Remove the coolant reservoir cap,
1
9-15
er.
1
add coolant to the maximum level
mark, and then install the reservoir
cap. WARNING! Remove only
the coolant reservoir cap. Never
attempt to remove the radiator
cap when the engine is hot.
NOTICE: If coolant is not
[EWA15162]
available, use distilled water or
soft tap water instead. Do not
use hard water or salt water
since it is harmful to the engine.
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the cooling system will not