Yamaha VINO XC50W Owner's Manual page 43

4 3
1
ZAUM00**
1. Engine oil drain bolt B
2. O-ring
3. Compression spring
4. Strainer
cC
When removing the engine oil drain
bolt B, the O-ring, compression
spring, and oil strainer will fall out.
Take care not to lose these parts.
4. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the oil strainer, compression
spring, O-ring and engine oil drain
bolt B.
PERIODIC MAINTENANCE AND MINOR REPAIR
NOTE:
2 1
Make sure that the O-ring is properly
seated.
7. Install engine oil drain bolt A, and
then tighten both drain bolts to their
specified torques.
Tightening torque:
Engine oil drain bolt A:
23 Nm (2.3 m • kgf, 16.6 ft • lbf)
Engine oil drain bolt B:
32 Nm (3.2 m • kgf, 23.1 ft • lbt)
ECAT1020
ZAUM00**
1. Oil filler hole
8. Add the specified amount of the
cC
8 8 8 8 8 Do not use oils with a diesel
8 8 8 8 8 Be sure no foreign material en-
9. Start the engine, and then let it idle
1
10. Turn the engine off, and then check
6-9
recommended engine oil, and then
install and tighten the oil filler cap.
Recommended engine oil:
See page 8-1.
Oil change quantity:
0.78 L (0.82 US qt) (0.69 Imp.qt)
specification of "CD" or oils of a
higher quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
ters the crankcase.
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off and
check for the cause.
the oil level and correct it if neces-
sary.
1
2
3
ECA11670
4
5
6
7
8
9