Coolant - Yamaha xenter HW125 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
3
1. Final transmission oil drain bolt
6. Install the final transmission oil
4
drain bolt and its new gasket, and
then tighten the bolt to the speci-
5
fi ed torque.
6 Tightening torque:
Final transmission oil drain bolt:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
7
7. Refi ll with the specifi ed amount of
the recommended fi nal transmis-
8
sion oil. WARNING! Make sure
that no foreign material enters
9
the final transmission case.
Make sure that no oil gets on
the tire or wheel.
Recommended final transmission
oil:
See page 8-1.
Oil quantity:
0.2 L (0.21 US qt, 0.18 Imp.qt)
1
8. Install the final transmission oil
fi ller cap and its new O-ring, and
then tighten the oil fi ller cap.
9. Check the fi nal transmission case
for oil leakage. If oil is leaking,
check for the cause.
[EWA11311]

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specifi ed in the periodic maintenance
and lubrication chart.
To check the coolant level
The coolant level should be checked
as follows before each ride. In addi-
tion, the coolant must be changed at
the intervals specified in the periodic
maintenance and lubrication chart.
1. Place the vehicle on the center-
TIP
●
●
6-13
stand.
T h e c o o l a n t l e v e l m u s t b e
checked on a cold engine since
the level varies with engine tem-
perature.
Make sure that the vehicle is po-
sitioned straight up when check-
ing the coolant level. A slight tilt
to the side can result in a false
EAU1722A
EAU20070
EAUT3690