Rear/Bottom Panel - Sony LMD-1751W Operating Instructions Manual

DISPLAY" on page 26, "MARKER ENABLE" on page 27,
and "MULTI DISPLAY ENABLE" on page 28).
*9 The signal can only be selected in the main display (see
"SUB INPUT SELECT" on page 28).

Rear/Bottom Panel

4 5
qa
a Power switch
The power is turned on or off.
The monitor is turned on by pressing side ?.
b AC IN socket
Connect the supplied AC power cord.
c DC 24V IN connector (LMD-2451W) / DC 12V
IN connector (LMD-1751W)
Plug the DC power supply to this connector to provide
power to the monitor.
LMD-2451W runs on DC 24V and LMD-1751W runs
on DC 12V.
Note
Be sure to connect to a power supply of the specified
voltage value.
d AUDIO L/R IN connectors (phono jack)
Connect to the audio outputs of a VCR or to an audio
mixer.
e COMPOSITE IN connector (BNC)
12
Location and Function of Parts and Controls
6 7 8 9 0
qs
*10 When a BKM-244CC is installed, closed captions are
displayed.
*11 When a BKM-250TG is installed, the signal is input.
1 2 3
– +
qd
qf qg qh qj
Input connector for composite signals.
f Y/C IN connector (4-pin mini-DIN)
Input connector for Y/C signals.
g G/Y IN connector (BNC)
Input connector for G of RGB signals and component Y
(luminance) signals.
h B/P
IN connector (BNC)
B
Input connector for B of RGB signals and P
difference) of component signals.
i R/P
IN connector (BNC)
R
Input connector for R of RGB signals and P
difference) of component signals.
j EXT SYNC IN/OUT (external sync) connectors
(BNC)
To use the external sync signal, press the function button
that EXT SYNC is assigned (F1 button at the factory
setting).
IN connector
qk
(blue color
B
(red color
R