Device Connection - Huawei Aolynk DR814Q ADSL2+ User Manual

User Manual
Aolynk DR814Q ADSL2+ Broadband Router
Keep the cabinet or desk stable enough to hold the DR814Q. Fix the DR814Q and
power adapt
Reserve more than 10 cm (4 in.) of clearance around the DR814Q chassis for heat
dissipation.
Keep the operation environment clean. Dust buildup on the chassis may result in
static absorption, reducing the life span and causing commu
Use an earthing system or lightning protection grounding different from that for the
power supply equipment and keep them as far as possible.
Wire the port ca
port from damages that may be cau
lightning strike.

2.3 Device Connection

Figure 2-1 Connect the DR8
I. Connect to an ADSL line
To c onnect the DR814Q to an ADSL line, two options are available:
Connect one
telephone port) on the DR814Q rear panel, and the other end to the telephone jack
on the wall.
As shown in Figure 2-1, connect both the ADSL port on the DR814Q
telephone to a splitter, and then con
wall. It allows you to use the
II. Connect to a PC or Ethernet
To connect the DR814Q to a PC or Ethernet, two options are available:
er well on the wall when wall-mounting it.
ble indoors. Outdoor cabling is prohibited, to prevent the signal
LAN USB ADSL
DR814Q
PC
14Q
end of the telephone cable to the ADSL port (similar to a common
sed by overvoltage and overcurrent from
Telephone jack
Line
Splitter
ADSL Phone
nect the splitter to the telephone jack on the
telephone when you access the network.
6
2 Installation
nication failure.
Telephone
and the