Table of Contents
Advertisement
User Manual
Aolynk DR814Q ADSL2+ Broadband Router
Figure 6-1 Use the ping command – the ping succeeds
If the destination PC is not reachable, the Request timed out message is displayed as
follows:
Figure 6-2 Use the ping command – the ping fails
To check the connectivity with the DR814Q, use the ping command with the default IP
address of the LAN port (192.168.1.1) or the address you assign.
To check the connectivity with the Internet, enter an Internet domain name, such as
www.yahoo.com (216.115.108.243).If you want to look up the IP address of a website,
use the nslookup command as instructed in section 6.2.2 "Nslookup" for details.
For other operating systems running the IP protocol, you can enter the same ping
command at a command prompt or through a system administration utility.
6.2.2 Nslookup
The nslookup command is used to query the IP address associated with a domain
name. You can specify the common domain name and use the nslookup command to
look up in the DNS server (usually located though your ISP).If that name is not in your
ISP's DNS table, the request is then sent to a higher-level server until the name is found.
The server then returns the associated IP address.
On Windows-based computer, you can execute the nslookup command from the [Start]
menu. Choose [Start/Run] and in the open text box type the following:
58
6 Troubleshooting
Advertisement
Table of Contents
