Table of Contents
Advertisement
User Manual
Aolynk DR814Q ADSL2+ Broadband Router
Figure 5-1 PVC attachment settings
As Figure 5-1 shows, there are five options for each Ethernet port (LAN1 to LAN4) in
the drop-down list: Attached to PVC1/2/3/4 and Attached to Router (Default).
Upon the configuration of these LAN ports, you need to click <Apply> to save your
configuration and have it take effect. Then in the [PVC Setting] section set VPIs/VCIs
for the corresponding PVCs. Values of VPI/VCI are provided by your ISP. Click <Apply>
in this section to save your configuration.
Caution:
You can manage your DR814Q only through the PC connected to the management
port or the USB port.
It is recommended to configure at least one Ethernet port as management port. If all
the four Ethernet ports are configured to be bound to PVCs, you can still access the
configuration management page through the USB port. Refer to Chapter 8
"Appendix – USB Configuration" for more information about the USB port.
The VPI/VCI values of different PVCs cannot be identical with each other or the
same as those on the other configuration pages.
The following example illustrates the configuration upon the assumption:
37
5 Advanced Configuration
Advertisement
Table of Contents
