Table of Contents
Advertisement
User Manual
Aolynk DR814Q ADSL2+ Broadband Router
The Ethernet ports of the DR814Q are auto-MDI/MDIX, so you can use the
crossover or straight-through cable to connect your PC, Hub, or switch to the
Ethernet port (one among LAN1 through LAN4) of the DR814Q.
Connect your PC to the DR814Q through the USB ports with a USB cable. It is
suitable for the PC without NIC to access the Internet.
Caution:
To use the USB port on the DR814Q, you must install the USB driver and configure
your PC (refer to section 8 "Appendix – USB Configuration" for detailed information).
III. Connect to the power adapter
Attach one end of the power adapter to the DR814Q and the other end to the power
outlet. Approximately one minute later, the states of the LEDs on the front panel should
be those listed in Table 2-2.
Table 2-2 Description of the LED states
LED
Power
Link
Act
LAN
USB
Diag
State
ON
The power is ON and the operation is normal.
ON
The ADSL link is normal.
Data is being transmitted and/or received on the
Blinking
ADSL link.
ON/Blinking
(when
a
LAN
The Ethernet link is normal.
connection
is
present)
ON/blinking
(when a USB
The USB connection is normal.
connection
is
present)
OFF
Contact the agent for help if this LED is ON.
Description
7
2 Installation
Advertisement
Table of Contents
