Back Of The Switch; Cl Module Slot; Rps Input Port; Power Connector - HP ProCurve 6400cl Installation And Getting Started Manual

Procurve series switches

Hide thumbs Also See for ProCurve 6400cl:

Table of Contents

Back of the Switch

The back of both 6400cl Series switches look the same.

Cooling vents - make sure this is not

obstructed for proper switch operation

Optional cl module slot

This switch supports one of two types of cl modules:

10-GbE Copper cl Module (J8434A) - provides two CX4 fixed copper ports

10-GbE Media-Flex cl Module (J8435A) - provides two flexible media slots

that support a number of different transceivers. See the ProCurve Switch

cl Modules Installation Guide for more information on supported

transceivers.

The Series 6400cl Switch supports connectivity to a redundant power supply.

The "ProCurve 600 Redundant and External Power Supply (RPS/EPS)

(J8168A) is an accessory product for the Series 6400cl Switch devices. The

RPS/EPS provides redundant power to any one of up to six switch products,

to back up the power supply in the switch in case of loss of AC power. See

Step 8 of the installation instructions

The Series 6400cl Switch devices do not have a power switch; they are

powered on when connected to an active AC power source. These switches

automatically adjust to any voltage between 100--240 volts and either 50 or 60

Hz. There are no voltage range settings required.

Introducing the Switch

ProCurve Series 6400cl Switch

AC power connector

RPS Input Port

page 2-15

for more information.

Back of the Switch

1-9

Table of Contents