HP AlphaServer GS80 Upgrade Manual page 41

CAUTION: Proper alignment during the insertion of the PCI box in the cabinet
is critical. Two people are needed to lift the PCI box and slide it
gently onto the ball bearing track. Any mishandling or
misalignment at this stage could damage the hardware and result
in jamming.
Install the PCI box as follows:
1. Lift the PCI box and gently insert the rear sides of the inner tracks fastened
on the sides of the PCI box into the outer ball bearing tracks attached to the
cabinet. Visually align the track to the bearings and slide the PCI box all
the way in maintaining steady alignment until fully engaged. Slide the PCI
box out and in again to ensure free movement on the track. Tighten the
screws mounting the brackets to the cabinet rails.
2. Attach the latching bracket to the side of the PCI box
screws (see Figure 3–4). Since you may need to adjust these screws later, do
not tighten them at this point. Repeat this step at the opposite side of the
PCI box.
3. Push the PCI box gently into the cabinet. The plastic latches should engage
with the latch retainer brackets on the cabinet. When this happens, you
should hear a latching click and the PCI box should sit snug and firm in the
cabinet. If the PCI box does not latch into place, pull it out and adjust the
position of the latching brackets. You may need to make these adjustments
a couple of times before a successful latching occurs.
4. Attach the power cable
first AC input box. If there is redundant power, then attach J2 to J8.
Attach the console serial bus (CSB) cable
box.
The installation of the PCI box is complete.
to J1 for an 8-processor system and to J7 of the
using two M4
to the J9 connector on the PCI
PCI Box Installation 3-9