HP AlphaServer GS80 Upgrade Manual page 39

Prepare the cabinet for installation as follows:
1. Select the location in the system cabinet or expander cabinet where the PCI
box is to be installed. Refer to the configuration rules given in Section 3.2.
2. Attach the two track mounting brackets (P/N 7452428-01)
ends of the outer track bracket with two M4 x 6 truss head screws for each
bracket . The front track mounting bracket has an insert
alignment. Tighten the two screws in the front bracket but leave the other
screws loose for later adjustment and tightening on the rear bracket. Do not
use insert to mount the rear bracket. Do the same on the second outer track
bracket.
CAUTION: It is very important to have the brackets loose until the PCI box is
mounted on the rails. Tightening the track mounting bracket at
this stage will cause difficulty and may result in jamming when
sliding the PCI box into the cabinet later in the procedure.
3. Locate the pattern of four holes on the selected area in the cabinet where
the PCI box is to be installed.
4. Place U-nuts on each of the four holes in the back cabinet rail and two U-
nuts on the two outermost holes in the front cabinet rail
5. Align the mounting rail brackets with the front and rear of the cabinet rails
and attach the mounting rail bracket to the cabinet rails with two M5
screws on the outermost holes of each mounting rail bracket
6. Mount the second rail on the other side of the cabinet following steps 3 to 5
above.
7. Attach the snap latch retainer bracket
and the cabinet rail at the inner holes of the 4-hole pattern using two M5
screws. Ensure that the snap latch retainer bracket is aligned properly to
engage with the plastic latch to be placed on the PCI box after mounting.
Repeat this step at the opposite side of the PCI box.
The cabinet is ready for the installation of the PCI box.
.
to the rear rail mounting bracket
PCI Box Installation
to the two
for
.
3-7